Mounting Prongs 1 and 2

The second item that I considered to be a hard part was dealt with last night. The holes through the mounting prongs were constructed using quarter inch inside diameter styrene tube.

The internal 'U' shaped part with the greeblie detail I made yesterday was then added and after that the next bulkhead.

The mounting prongs still need to have the external skin added, hopefully this will be a quick and easy process.

I have been doing some thinking on the next part of the hull and as I have only on bulkhead left to make from the paper templates, it seemed insufficient to me. I have decided that the best way forward is to make three of these bulkheads ans position them one at each end (one being the end part of the model) and one in the center to add rigidity and strength.

That's it again until next time.